To Remove A Pcie2 X16 Card; Figure - Sun Microsystems Ultra 27 Service Manual

▼

To Remove a PCIe2 x16 Card

Power off the workstation using the procedure described in the section,
1
Workstation"on page
Remove the left-side access panel using the procedure described in the section,
2
Left-Side Access Panel"on page
Gently lay the system on its right side on a stable, nonslip surface.
3
Remove any cables connected to the card.
4
Some graphics cards require supplemental power, which is supplied by connecting an
Note –
auxiliary power cable directly from the power supply to the card.
If necessary, disconnect the supplemental power connector from the card.
5
Use a #2 screwdriver to remove the card retaining screw.
6
Pull gently upward on the card while pressing the release latch (see
7
This combined action releases the card, allowing you to remove it from the workstation.
Chapter 3 • Maintaining the Workstation
30.
31.
Removing and Installing a PCIe2 x16 Card
"To Power Off the
"To Remove the

Figure

3–18).
57