Opening the Workstation
Power off the workstation using the procedure described in section,
2
Workstation"on page
Turn the power switch on the back of the chassis to the Off position (0).
3
Caution –
cause serious component damage.
To maintain system grounding, do not unplug the AC power cord from the back of the system
4
unless the specific procedure instructs you to unplug it.
Power off all peripherals connected to the workstation.
5
Loosen the two captive thumbscrews located on the rear edge of the left-side access panel (see
6
Figure
Slide the access panel approximately 1.5 cm toward the back of the workstation.
7
Tilt the top edge of the panel out, then lift the panel upward.
8
Set the panel aside.
9
32
Sun Ultra 27 Workstation Service Manual • June 2009, Revision A
30.
Failure to properly turn off the system before you start installing components can
3–1).
Removing the Side Access Panel
FIGURE 3–1
"To Power Off the