Using a No. 2 Phillips screwdriver, remove the chassis filler panel for the slot from the internal
6
side of the workstation chassis back panel.
Retain the screw for the next step.
Insert the SAS card with attached cables into the PCIe slot 5, and secure the card with a screw
7
(see
Figure
3–7).
To keep the cables out of the air flow, carefully secure them in the tie-downs.
8
Installing a SAS Card
FIGURE 3–7
Install the SAS drives using the procedures in the section,
9
Chapter 3 • Maintaining the Workstation
Converting From SATA to SAS
"To Install a Hard Drive"on page
40.
43