Installing The Storage Backplane; Figure - Sun Microsystems Ultra 27 Service Manual

Replacing the Storage Backplane
Lower the new storage backplane into the hard drive cage connector end first and ensure that
12
the connectors on the bottom edge of the board slip under the lower edge of the hard drive
cage.
Lay the storage backplane board onto the threaded standoffs.
13
Align the screw holes in the board with the screw holes in the threaded standoffs.
14
Fasten the storage backplane to the threaded standoffs using the five mounting screws.
15
Connect the power connector and the black, blue, green, and red storage interface connectors
16
to the connectors on the bottom edge of the storage backplane board.
Position the hard drive cage support bracket so that the edge of the bracket with the green
17
captive screw is facing down.
48 Sun Ultra 27 Workstation Service Manual • June 2009, Revision A

Installing the Storage Backplane

FIGURE 3–11