Maintaining The Workstation - Sun Microsystems Ultra 27 Service Manual

3
C H A P T E R 3

Maintaining the Workstation

This chapter provides instructions on how to prepare the workstation for service and add,
replace, and configure components. The following sections are included in this chapter:
Preparing the Workstation for Service and Operation
"Powering the Workstation On and Off" on page 30
■
"Observing Electrostatic Discharge (ESD) Precautions" on page 31
■
"Required Tools and Supplies" on page 31
■
"Opening the Workstation" on page 31
■
"Closing the Workstation and Preparing for Operation" on page 34
■
"Component FRU and CRU List " on page 36
■
Removal and Replacement Procedures
"Removing and Installing a Hard Drive" on page 37
■
"Converting From SATA to SAS" on page 42
■
"Replacing the Storage Backplane" on page 44
■
"Replacing the DVD Drive" on page 50
■
"Removing and Installing DIMMs" on page 53
■
"Removing and Installing a PCIe2 x16 Card" on page 56
■
"Adding Supplemental Power to PCIe2 Cards" on page 60
■
"Removing and Installing PCIe Cards" on page 64
■
"Replacing the System Battery" on page 67
■
"Replacing the System Fan" on page 69
■
"Replacing the Power Supply" on page 72
■
"Replacing the I/O Board Assembly" on page 75
■
"Replacing the System Cables" on page 77
■
"Replacing the Heat Sink and CPU" on page 78
■
"Replacing the Motherboard" on page 84
■
"Updating the BIOS and Accessing the BIOS Setup Utility" on page 87
■
29