Closing The Workstation And Preparing For Operation; Close The Workstation And Prepare Of Operation; Install The Front Bezel; Installing The Front Bezel - Sun Microsystems Ultra 27 Service Manual

Closing the Workstation and Preparing for Operation

Gently move the bezel slightly to the left and gently pull forward to disengage the three chassis
3
hooks on the right side.
Remove the bezel and set it aside.
4
Closing the Workstation and Preparing for Operation
This section describes how to prepare for service and install the left-side access panel and the
front bezel.
▼

Close the Workstation and Prepare of Operation

Perform the following steps after installing a workstation component.
Ensure that all the components are removed, replaced, or installed as described in the removal
1
and replacement procedures.
Ensure that all cables are secure and do not block the internal airflow or touch components on
2
the motherboard.
Remove tools and debris from the interior of the workstation.
3
Install the front bezel as described in the procedure,
4
Install the left-side access panel as described in
5
Connect all external cables to the system, and then connect the AC power cord.
6
Power on the workstation.
7
See
▼

Install the Front Bezel

Insert the right side bezel hooks into the right side chassis slots. See
1
Insert the left-side bezel tabs into the chassis slots, and gently press the left side of the bezel
2
toward the chassis until the tabs lock.
34 Sun Ultra 27 Workstation Service Manual • June 2009, Revision A
"To Power On the Workstation" on page
"Install the Front Bezel"on page
"Install the Left-Side Access Panel"on page
30.
Figure
34.
35.
3–3.