To Remove The Front Bezel; Figure - Sun Microsystems Ultra 27 Service Manual

▼

To Remove the Front Bezel

Do not remove the front bezel unless removal is required to perform a maintenance
Note –
procedure.
Perform the steps described in the section,
1
Unlatch the three left-side bezel tabs by gently pressing the side of each tab inward and slightly
2
forward (see

Figure

The edge of the bezel nearest the tabs moves slightly away from the front of the chassis as the
ridges holding each tab in place are released.
The bezel tabs and the chassis hooks might break if you apply too much force or
Caution –
attempt to swing the bezel open. Be very careful when pulling the bezel away from the chassis.
Removing the Front Bezel
FIGURE 3–2
Chapter 3 • Maintaining the Workstation
"To Remove the Left-Side Access Panel"on page
3–2).
Opening the Workstation
31.
33