Gently lay the system on its right side on a stable, nonslip surface.
3
Refer to the service label on the inside of the access panel or the section,
4
Expansion Slots"on page
card that you are installing.
Use a #2 screwdriver to remove the back panel slot filler bracket.
5
Position the PCIe2 x16 card in the selected slot. Ensure that the notch in the connector on the
6
motherboard is aligned with the notch in the connector of the card and that the notch in the
end of the card engages the retainer (see
Installing a PCIe Graphics Card
FIGURE 3–19
Press down on the card until it is completely seated in the slot.
7
The card should sit evenly in the connector.
If you are installing a card (or cards) that requires supplemental power, see
8
Supplemental Power to PCIe2 Cards"on page
Secure the card to the chassis using the retaining screw.
9
Chapter 3 • Maintaining the Workstation
108, to help you choose an empty card slot that is compatible with the
Figure
3–21).
60.
Removing and Installing a PCIe2 x16 Card
"PCIe and PCI
"Adding
59