Replace The Shocks; Hardware Torque - Taylor-Dunn ET-3000 Manual

Suspension

REPLACE THE SHOCKS

It is recommended to replace all shocks as a set.
Note: On some vehicles it may be required to remove the front wheel to
6. Some vehicles may require that the wheels be lifted off of the ground and supported with jack
stands to replace the shocks.
7. Remove the upper and lower shock bolts.
8. Remove the shock from the vehicle.
Note: If the shock that was removed is to be
9. Install the shock in reverse order.
10. Lower the vehicle.
11. Reconnect the main positive and negative cables at the
batteries.
12. Remove the blocks from behind the wheels.
13. Release the parking brake and test drive the vehicle.

HARDWARE TORQUE

If hardware is not listed here, refer to standard torque
values in the appendix.
Description
Spring Hanger Bolts
Page 6
gain access to the shock mounting bolts. Refer to Tires and Wheels
section for information regarding removing the front wheels.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily
reinstalled:
A. Inspect the shaft where it enters the shock
body for any signs of leakage. If any sign
of leakage is seen, then the shock must
be replaced.
B. Inspect the upper and lower shock bushings.
If any signs of damage or wear are seen,
then the shock must be replaced.
Foot Pounds Newton Meters
20
T-48 AC / ET 3000
MB-T48-02