(4)
Press SW2 on the saddle stitcher controller PCB so that the feed motor (M1S) starts to rotate.
(Press SW2 three seconds or more if LD paper is used).
(5)
Open the inlet cover, and insert two sheets of paper (push them in by hand until the leading edge
of the sheets butts against the paper positioning plate).
(6)
Close the inlet door while holding it down with your hand.
(7)
Press SW2 on the saddle stitcher controller PCB.
•
The saddle stitcher unit will "stitch" the sheets, and fold and deliver the stack automatically.
e-STUDIO520/600/720/850 ADJUSTMENT
Sheets
Mark
3 - 74
March 2005 © TOSHIBA TEC