Toshiba e-studio600 Service Manual page 314

During replacement, coat the oil seal with grease (Alvania No.2).
(1) Push in a new oil seal parallel to the mount-
ing hole section of the developer frame or
outside of the nozzle mixer.
* Pay attention to the direction in which the
oil seal is attached. (See figure on right.)
(2) Apply an even coat of grease to the inside of
the oil seal.
• Amount: About two small drops
(3) Wipe off any grease the exudes from the
inside.
Mixer Shaft
Apply a coating of grease (Alvania No.2) to the entire periphery of the mixer shaft before attaching the
bearing.
e-STUDIO520/600/720/850 PREVENTIVE MAINTENANCE (PM)
Mixer Shaft
Fig.4-21
4 - 26
Inside
Fig.4-20
Bearing
Developer frame
( Nozzle mixer )
Outside
Grease
Oil seal
March 2005 © TOSHIBA TEC