Toshiba e-studio600 Service Manual page 71

Classi-
Code
fication
299 Image Image quality open-loop
quality control enforcement
control
305 Scanner Image location adjustment
of secondary scanning
direction
(scanner section)
306 Scanner Image location adjustment
of primary scanning direc-
tion
(scanner section)
308 Scanner Distortion mode
310 Scanner Shading posi-
tion adjust-
ment
311
340 Scanner Reproduction ratio adjust-
ment of secondary scan-
ning direction
(scanner section)
352 RADF EEPROM initialization
354 RADF Adjustment of
RADF paper
alignment
355
March 2005 © TOSHIBA TEC
Adjustment mode (05)
Default
Func- <Accept-
Items
tion
ALL
ALL
<92-164>
ALL
<0-255>
ALL
Original ALL
glass
RADF ALL
ALL
<0-255>
ALL
for single - ALL
sided orig- <0-20>
inal
for double ALL
sided orig- <0-20>
inal
e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 47
RAM Contents
able
value>
- M When a service call has
occurred or a warning
message (IQC/SPC) has
appeared, "Image quality
control enforcement (05-
290)" should be per-
formed after the equip-
ment is repaired or the
cause of the error is
evaluated. In case the
service call occurred or
the warning message
(IQC/SPC) appeared
again after the perfor-
mance of the code 05-
290, a test chart can be
printed out by tempo-
rarily using this code (05-
299) if an image check is
urgently needed.
140 SYS When the value
increases by "1", the
image shifts by approx.
0.143 mm toward the
trailing edge of the
paper.
135 SYS When the value
increases by "1", the
image shifts by approx.
0.169 mm toward the
front side of the paper.
- - Moves carriages to the
adjusting position.
(Ch.3.2.4)
0 SYS 0.1433 mm/step
<0-11>
0 SYS 0.1433 mm/step
<0-5>
128 SYS When the value
increases by "1", the
reproduction ratio in the
secondary scanning
direction (vertical to
paper feeding direction)
increases by approx.
0.223%.
- SYS EEPROM is initialized.
10 SYS When the value
increases by "1", the
aligning amount
increases by approx.
10 SYS
0.5 mm.
Proce-
dure
6
2
1
1
6
1
1
1
6
1
1