Toshiba e-studio600 Service Manual page 32

Error code Classification
EAE0 Finisher jam
EB30
EB50 Paper transport jam
EB60
EC00 Finisher jam
(Inserter section)
EC10
EC20
EC30
EC40
EC50
EC60
EC70
EC80
EC90
ECA0
ECB0
ECC0
ECD0
e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Receiving period time-out jam: The printing cannot
be finished normally due to the communication
error between the equipment and the Finisher when
the paper is transported from the equipment to the
Finisher.
Ready period time-out jam: The equipment judges
that the paper transport to the Finisher is disabled
due to the communication error between the equip-
ment and the Finisher at the start of the printing.
Paper remaining on the transport path: The multiple
feeding of the preceding paper caused the misfeed-
ing of the upcoming paper.
Paper remaining on the transport path: The multiple
feeding of the preceding paper caused the misfeed-
ing of the upcoming paper (= redetection after no
jam is detected at [EB50]).
Inserter feeding delay jam
Inserter feeding stop jam
Inserter reverse path delay jam-1
Inserter reverse path stop jam-1
Inserter reverse path delay jam-2
Inserter reverse path stop jam-2
Inserter transport delay jam-1
Inserter transport stop jam-1
Inserter transport delay jam-2
Inserter transport stop jam-2
Paper remaining in Inserter Unit at power-ON
Incorrect setting of paper size for Inserter Unit
Inserter Unit misfeeding
Inserter Unit door open jam
2 - 8
Troubleshooting
Ch.5.1.5 [ 5 ]
Ch.5.1.5 [ 5 ]
Ch.5.1.1
Ch.5.1.1
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
Ch.5.1.5 [ 4 ]
March 2005 © TOSHIBA TEC