Toshiba e-studio600 Service Manual page 415

[Procedure 3]
Is the paper pushing plate top position sensor (PI15S) connected to the saddle stitcher con-
troller PC board?
NO Æ
È
YES
Is the wiring between the sensor and the saddle stitcher correct?
YES Æ Correct the wiring.
È
NO
Is 5V DC being supplied from J9-13 on the saddle stitcher controller PC board?
NO Æ
È
YES
Is J9-14 on the saddle stitcher controller PC board properly connected to the ground?
NO Æ
È
YES
END
March 2005 © TOSHIBA TEC
Connect it to the board.
Replace the saddle stitcher controller PC board.
Replace the saddle stitcher controller PC board.
5 - 87
e-STUDIO520/600/720/850 TROUBLESHOOTING
5