Toshiba e-studio600 Service Manual page 333

[E061] Incorrect paper size setting for 1st drawer
[E062] Incorrect paper size setting for 2nd drawer
[E063] Incorrect paper size setting for 3rd drawer
[E064] Incorrect paper size setting for 4th drawer
[E065] Incorrect paper size setting for bypass tray
If any paper remains in the equipment or drawer, remove it. Match the paper size of the
drawer setting and the one in the drawer.
* Paper size detection is performed at the first sheet of paper when the drawer is opened
or closed, or when the power of the equipment is turned ON.
[E090] Image data delay jam
1) Remove the paper remained in front of the registration sensor.
2) Check if the error is cleared by turning the power OFF and then back ON.
3) Check if the connectors connecting the SYS board, SLG board and PLG board are dis-
connected.
4) Check if the connectors of the HDD are disconnected.
5) Check if the harnesses connecting the SYS board, SLG board and PLG board are open-
circuited.
6) Replace the HDD, SYS board, SLG board and PLG board.
[E200] 1st drawer transport jam (paper not reaching registration sensor)
[E210] 2nd drawer transport jam (paper not reaching registration sensor)
[E300] 3rd drawer transport jam (paper not reaching registration sensor)
[E330] 4th drawer transport jam (paper not reaching registration sensor)
[E3C0] Tandem LCF transport jam (paper not reaching registration sensor)
(First page of printing)
Open the jam access cover. Is there paper in front of the registration sensor?
YES Æ Replace the paper.
È
NO
Is the registration sensor(S18) working?
(Perform the input check in the test mode: 03-[FAX]ON/[4]/[E])
NO Æ
l
l
l
l
l
l
l
l
È
YES
1) Check the transport roller. Replace it if it is worn out.
March 2005 © TOSHIBA TEC
1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN305 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the registration sensor.
6) Replace the LGC board.
5 - 5
e-STUDIO520/600/720/850 TROUBLESHOOTING
5