Toshiba e-studio600 Service Manual page 418

Multifunctional digital systems

Hide thumbs Also See for e-studio600:

Table of Contents

[CC40] Swing motor abnormality

[Procedure 1]

Rotate the swing motor in reverse by hand. Does the swing guide move up and down?

Is the swing guide closed detection switch-2 (MS6) working normally?

Is the swing guide open sensor (PI18) working normally?

Is the swing motor (M7) rotating in reverse at the fixed timing?

[Procedure 2]

Is the safety zone switch (MS3) working normally?

Is the safety zone switch (MS3) correctly pressed?

Is the swing guide closed detection switch-2 (MS6) working normally?

Is the swing guide closed detection switch-2 (MS6) correctly pressed?

Replace the finisher controller PC board.

[Procedure 3]

Is the swing motor clock sensor (PI20) working normally?

e-STUDIO520/600/720/850 TROUBLESHOOTING

Fix the swing mechanism.

Replace the switch.

Replace the sensor.

Replace the motor.

Replace the switch.

Fix the mechanism.

Replace the switch.

Fix the mechanism.

Show Quick Links

Table of Contents

Troubleshooting

E-studio720 E-studio850 E-studio520