Toshiba e-studio600 Service Manual page 382

[ECA0] Paper remaining in Inserter Unit at power-ON
Is there any paper remaining at the inserter transport path?
YES Æ Remove the paper.
È
NO
Are the separation sensor, reverse path sensor and transport sensor working improperly?
YES Æ Replace the sensors.
È
NO
Replace the inserter control board.
[ECB0] Incorrect setting of paper size for Inserter Unit
Is the paper size on the inserter tray consist with the size set at the copier control panel?
NO Æ
È
YES
Is the separation sensor working improperly?
YES Æ Replace the separation sensor.
È
NO
Perform the width adjustment of the inserter tray side guide.
[ECC0] Inserter Unit misfeeding
Is the condition improved when the copier power switch is turned OFF/ON?
È
NO
1) Replace the copier LGC board.
2) Replace the IPC board.
3) Replace the inserter control board.
[ECD0] Inserter Unit door open jam
Is the problem solved by opening the inserter jam access cover?
È
NO
1) Check the installation state of the cover.
2) Replace the cover switch and plate spring.
e-STUDIO520/600/720/850 TROUBLESHOOTING
Set the same paper size as that on the tray.
5 - 54
March 2005 © TOSHIBA TEC