Toshiba e-studio600 Service Manual page 464

11)Skew (inclined image)
Defective area
Drawers
LCF
Feed roller
Rollers
Alligning amount
Registration roller
Pre-registration guide
Carriage-1
e-STUDIO520/600/720/850 TROUBLESHOOTING
Step Check items
1 Is the drawer or LCF properly
installed?
2 Is there too much paper in the drawer
or LCF?
3 Is the corner of the paper folded?
4 Are the side guides of the drawer or
LCF properly installed?
5 Is the surface of the feed roller dirty?
6 Are the roller and shaft secured?
7 Is the aligning amount proper?
8 Is the spring detached from the regis-
tration roller?
9 Is the pre-registration guide properly
installed?
10 Is the carriage-1 slanted?
Fig.5-11
Install the drawer or LCF properly.
The height of paper stack should not
exceed 55 mm.
137 mm or lower/room for tandem
LCF.
428 mm or lower for external LCF.
Change the direction of the paper
and set it again.
Adjust the position of the side guides.
Clean the feed roller surface with
alcohol, or replace the roller.
Check and tighten the E-rings, pins,
clips and setscrews.
Increase the aligning amount.
Attach the spring correctly. Clean the
roller if it is dirty.
Correct it.
Adjust the carriage-1.
5 - 136
Prescription
March 2005 © TOSHIBA TEC