Self-Diagnosis Modes - Toshiba e-studio600 Service Manual

2.2

Self-diagnosis Modes

Mode For start
Control panel [0]+[1]+
check mode [POWER]
Test mode [0]+[3]+
[POWER]
Test print [0]+[4]+
mode [POWER]
Adjustment [0]+[5]+
mode [POWER]
Setting mode [0]+[8]+
[POWER]
List print mode [9]+[START]
+[POWER]
PM support [6]+[START]
mode +[POWER]
Firmware [8]+[9]+
update mode [POWER]
Note: Note:
To enter the desired mode, turn ON the power while two digital keys designated to each mode
(e.g. [0] and [5]) are pressed simultaneously.
To exit from Self-diagnosis modes:
Shut down the equipment by pressing the [ENERGY SAVER] button for a few seconds except for
the control panel check mode and the firmware update mode.
<Operation procedure>
• Control panel check mode (01):
[0][1]
[POWER]
Notes:
1. A mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
2. Button Check
Buttons with LED
Buttons without LED
Button on touch panel
e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
All LEDs on the control panel are lit, and all the
LCD pixels blink.
Checks the status of input/output signals.
Outputs the test patterns.
Adjusts various items.
Sets various items.
Prints out the data lists of the codes 05 and 08,
PM support mode and pixel counter.
Clears each counter.
Performs updating of the system firmware.
LED lit/
[START]
LCD blinking
[START]
(Press to turn OFF the LED.)
(Press to display the message on the control panel.)
(Press to display the screen on the control panel at power-ON.)
Contents
(Button check)
2 - 26
05/06
For exit Display
[POWER] -
OFF/ON
[POWER] 100% C A4
OFF/ON TEST MODE
[POWER] 100% P A4
OFF/ON TEST PRINT
[POWER] 100% A A4
OFF/ON TEST MODE
[POWER] 100% D
OFF/ON TEST MOD
[POWER] 100% UA A4
OFF/ON LIST PRINT
[POWER] 100% K
OFF/ON TEST MODE
[POWER] -
OFF/ON
[POWER] OFF/ON
(Exit)
March 2005 © TOSHIBA TEC