Toshiba e-studio600 Service Manual page 29

Error code Classification
E510 Paper transport jam
(Exit/Reverse section
or other sections)
E511
E512
E540
E550
E570
E580
E590
E5A0
E711 RADF jam
E712
E713
E714
E715
E716
March 2005 © TOSHIBA TEC
Contents
Transport jam during duplex printing (paper not
reaching reverse sensor-2): Paper which has
passed the reverse sensor-1 does not reach the
reverse sensor-2 during duplex printing.
Transport jam during duplex printing (paper not
reaching horizontal transport sensor-1): Paper
which has passed the reverse sensor-2 does not
reach the horizontal transport sensor-1 during
duplex printing.
Transport jam during duplex printing (paper not
reaching horizontal transport sensor-2): Paper
which has passed the horizontal transport sensor-1
does not reach the horizontal transport sensor-2
during duplex printing.
Transport jam during duplex printing (paper not
reaching horizontal transport sensor-3): Paper
which has passed the horizontal transport sensor-2
does not reach the horizontal transport sensor-3
during duplex printing.
Paper remaining jam at paper transport path: Paper
is remaining on the paper transport path when the
printing has finished. (Jam caused by a multiple
paper feeding)
Transport jam during duplex printing (paper not
reaching reverse sensor-1): Paper which has
passed the fuser unit transport sensor does not
reach the reverse sensor-1 during duplex printing.
Paper stopping at reverse section: The trailing edge
of paper does not pass the reverse sensor-1 or
reverse sensor-2 after its leading edge has reached
the reverse sensor-1 or reverse sensor-2.
Paper stopping at exit section: The trailing edge of
paper does not pass the exit sensor after its leading
edge has reached the exit sensor.
Paper not reaching exit sensor: The leading edge of
paper does not reach the exit sensor.
Original not reaching original length detection sen-
sor: An original fed out of the original feeding tray
does not reach the original length detection sensor.
Original not reaching registration sensor: An origi-
nal fed out of the original feeding tray does not
reach the original registration sensor.
Original stopping at original length detection sen-
sor: The trailing edge of the original does not pass
the original length detection sensor after its leading
edge has reached the original length detection sen-
sor.
Feed signal reception jam: The feed signal is
received while no original is placed on the original
feeding tray.
Tray lifting movement time-out: The lifting tray does
not reach the lifting tray upper limit detection sen-
sor.
Tray lowering movement time-out: The lifting tray
does not reach the lifting tray lower limit detection
sensor.
e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 5
Troubleshooting
Ch.5.1.1
Ch.5.1.1
Ch.5.1.1
Ch.5.1.1
Ch.5.1.1
Ch.5.1.1
Ch.5.1.1
Ch.5.1.1
Ch.5.1.1
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
2