Toshiba e-studio600 Service Manual page 65

Procedure 6
[Digital key]
[0][5]
(Code)
[POWER]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 7
[Digital key]
[0][5]
(Code)
[POWER]
*[CANCEL] or [CLEAR]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 17
[ CANCEL ] or [ CLEAR ]
[ 0 ][ 5 ]
[ Digital key ] [ START ]
[ POWER ]
( Code )
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
March 2005 © TOSHIBA TEC
Automatic
(
[START]
adjustment
*[CANCEL] or [CLEAR]
[CANCEL]
Automatic
(
[START]
adjustment
[Digital key]
[START]
(Sub code)
[SET] or [INTERRUPT]
(Value unchangeable)
[ ENTER ]
( )
Automatic
[ INTERRUPT ]
adjustment
(
Stores value
in RAM
e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 41
05/05
([FAX]
)
or
[COPY])
(Test copy)
([FAX]
[ENTER]
)
Stores value
( )
[COPY])
in RAM
(Test copy)
Value
( )
[START]
displayed
([ FAX ]
[ POWER ]
or or
OFF/ON
[ COPY ])
( Exit )
( Test copy )
)
[POWER]OFF/ON
(Exit)
[POWER]
or
OFF/ON
(Exit)
[POWER]
[START] OFF/ON
(Exit)
2