Toshiba e-studio600 Service Manual page 212

For tandem LCF
Order for
Paper source
adjustment
1 1st drawer
2 2nd drawer
3 Tandem LCF
4 LCF
5 Bypass feed
6 Duplexing
- All
<Procedure>
While pressing [0] and [5] simultaneously, turn the power ON. Æ (Adjustment Mode)
(1)
Press [1] ([3] for duplexing) Æ [FAX]. (A grid pattern with 10 mm squares is printed out.)
(2)
(3) Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance D is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
(Adjustment Mode) Æ (Key in the code shown above) Æ [START]
Æ (Key in an acceptable value shown above)
Æ [ENTER] or [INTERRUPT] (Stored in memory)
Æ "100% A" is displayed
Æ Press [1] ([3] for duplexing)Æ [FAX] Æ (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.4 mm/step).
e-STUDIO520/600/720/850 ADJUSTMENT
Code Paper size
440 A4
441 A3
429 A4
443 A4
442 A3
445 A3
408 -
3 - 12
Acceptable
value
0 to 40
0 to 40
0 to 40
0 to 40
0 to 40
0 to 40 Paper fed from the 2nd/4th drawer
0 to 80
Remarks
March 2005 © TOSHIBA TEC