Christie CP2000-ZX Setup Manual page 17

Installing a Permanent Connection
Follow these guidelines:

A 30-32A double pole, UL listed wall circuit breaker is required. It must be part of the building
installation and easily accessible.
 The distance between the wall circuit breaker and the projector must not exceed 20m using 10AWG
cables OR 30 metres using 8AWG cables. NOTE: In countries where UL listed products are not
available, use an equivalent circuit breaker as recommended by the electrical code of that country.
 For North American installations, use at least 10AWG copper wires for the connection of the main
AC supply to the projector's ground lug.
 Copper or aluminum are acceptable as conductor wiring material to the terminal block.
1. A small electrical access plate is located in the
lower right corner of the projector faceplate.
Loosen the two screws and slide the plate forward
to expose the terminal block underneath. See
Figure 2-10.
2. Remove the knockout plate located in the bottom
right corner of the front bezel. The AC supply is
routed to the terminal block through an
appropriate strain relief mounted on this knockout
plate.
3. Connect the AC power source to the terminal
block, beginning with the ground lead first. See
Figure 2-11 for wiring details. Use an appropriately sized strain relief connector with the knockout plate
provided to ensure adequate environmental sealing and to prevent the cables from wear and accidentally
being torn out. NOTES: 1) The terminal block accommodates up to a 8 AWG wire. 2) If desired, a 90°
strain relief connector can be used to route the power cable in a downward direction.
4. Once all cables are connected, replace the knockout plate
and the bottom access panel over the terminal block.
CP2000-ZX Setup Guide
020-100098-04 Rev. 1 (06-2009)
Figure 2-11 Steps to Connect AC Power to Terminal Block
Section 2: Installation & Setup
Figure 2-10 Steps to Connect AC Power
to Terminal Block
Figure 2-12 Re-attach Knockout and
Access Panel Plates
2-7