Connecting Sources - Christie CP2000-ZX Setup Manual

Section 2: Installation & Setup
2.2

Connecting Sources

Cinema servers, such as digital media storage devices or non-cinema sources such as PCs reside outside the
projector and are connected to one of the ports on the Projector Control Panel (PCM) located on the right-hand
side of the projector.
These communication ports are accessible by first removing the side access panel. When connecting sources or
servers, route all cables along the channel ways located on the bottom of the projector and up through the
opening in the frame to the communication connection port.
In most cases, it is recommended the access panel be replaced to ensure server and source connections remain
secure. NOTE: 1) To maintain radiated emissions compliance, do not connect I/0 cables to the projector
without connecting the source or receiver at the other end. 2) Right angle (75Ohm) BNC adapters are provided
which can be used when connecting to the 292A and 292B ports. This directs source cables downward and
enables full closure of the PCM cover.
2-10
PWR
(optional)
Figure 2-16 Connecting an External Cinema Server/Source
and Connecting Non-Cinema Servers/Sources
CPU
Connect to
AC at site
PWR CPU
Connect to
AC at site
CP2000-ZX Setup Guide
020-100098-04 Rev. 1 (06-2009)