Speed - Motorola RFS Series Reference Manual

12-32 Motorola RF Switch CLI Reference Guide

12.1.18 speed


Interface Config Commands
Specifies the speed of a fast-ethernet (10/100) or a gigabit-ethernet port (10/100/1000)
Displays current system information running on the switch.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
speed [10|100|1000|auto]
Parameters]
10
100
1000
auto
Usage Guidelines
Set the interface speed to auto to detect and use the fastest speed available. Speed
detection is based on connected network hardware.
Example
RFSwitch(config-if)#speed auto
RFSwitch(config-if)#
Forces 10 Mbps operation
Forces 100 Mbps operation
Forces 1000 Mbps operation
Port automatically detects the speed it should run based on
the port at the other end of the link.Autonegotiation is a
requirement for using 1000BASE-T[3] according to the
standard.