18.1.15 host
DHCP Config Commands
Defines a fixed IP address for the host in dotted decimal format
Use the
no host
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
host <IP>
Parameters
host <IP>
Usage Guidelines
The DHCP host pool (used to manually assign an IP address based on hardware address/
client identifier) configuration must contain a host IP address, client name and hardware
address/client identifier.
The host IP address must belong to a subnet on the switch. There must be a DHCP network
pool corresponding to that host IP address. There is no limit to the number of manual
bindings. However, you can configure only one manual binding per host pool.
Example
RFSwitch(config-dhcp)#host 2.2.2.111
RFSwitch(config-dhcp)#
command to remove the host from the DHCP pool.
Sets a fixed address for the host
• <IP > – Sets an IP address in dotted decimal
format
DHCP Server Instance
18-21