15.1.7 no
Extended ACL Config Commands
Negates a command or sets its defaults
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
no [deny|mark|permit]
Negates all the syntax combinations used in the deny, mark and permit designations to
configure the Extended ACL
Parameters
deny
mark
permit
Usage Guidelines
Removes an access list control entry. Provide the rule-precedence value when using the
no command.
Example
RFSwitch(config-ext-nacl)#no mark 8021p 5 tcp 192.168.2.0/24
any rule-precedence 10
RFSwitch(config-ext-nacl)#
RFSwitch(config-ext-nacl)#no permit ip any any rule-
precedence 10
RFSwitch(config-ext-nacl)#
RFSwitch(config-ext-nacl)#no deny icmp any any rule-
precedence 10
RFSwitch(config-ext-nacl)#
Specifies packets to reject
Specifies packets to mark
Specifies packets to forward
Extended ACL Instance
15-21