21-10
Motorola RF Switch CLI Reference Guide
Usage Guidelines
Use
command to undo the configurations on the parameters mentioned in the table.
no
Refer to the parameters, within this chapter, for complete syntax.
Example
RFSwitch(config-rtls)#no aeroscout enable
RFSwitch
RFSwitch(config-rtls)#no ekahau enable
RFSwitch(config-rtls)#
RFSwitch(config-rtls)#no
RFSwitch(config-rtls)#
RFSwitch(config-rtls)#no service inventory 1 zone 1
RFSwitch(config-rtls)#
21.1.10 reference-tag
RTLS Config Commands
Configures fixed RFID tag as reference tag and sets its coordinates within a specified
location
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
reference-tag rfid <tag-id> coordinates x <0-65535> y
<0-65535> {[z<0-65535>]}{orientation [0|90|180|270]}
{range <1-50>}
switch
• Negates switch configuration parameters
[coordinates
• coordinates – Negates switch coordinates
|geo-
coordinates]
• geo-coordinates – Negates switch geo coordinates
configuration within the site
configuration
ekahau engine