Sensor - Motorola RFS Series Reference Manual

20.1.45 sensor


Wireless Configuration Commands
Configures Wireless Intrusion Protection System (WIPS) parameters
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
sensor [<1-48>|default-config|ping-interval|vlan]
sensor <1-48> [default-config|request-config|revert-to-ap]
sensor default-config [gateway-ip|ip-mode|wips-server-ip]
sensor default-config gateway-ip <IP>
sensor default-config ip-mode [dhcp|static <IP/Mask>]
sensor default-config wips-server-ip [primary|secondary]
<IP>
sensor ping-interval <2-60>
sensor vlan <1-4094> {<1-4094>}
Parameters
<1-48> [default-config|
requestconfig|
revert-to-ap]
Select a sensor to reset/revert the AP to its original state.
Use the
show wireless sensor
sensor index.
• default-config – Restores the internal configuration of
the sensor to default values. This sends the
configuration to the sensor
• request-config – Polls the sensor for its latest
configuration
• revert-to-ap – Reverts an IDS sensor back to an access
port that can service mobile-units
Wireless Instance 20-91
command to view the