Table of Contents
Advertisement
OWNER'S RECOMMENDED PREVENTATIVE
MAINTENANCE
To keep shutter in good working condition, these are some things we recommend
doing:
• Keep guides of shutter system free from any debris at all times.
Every month
• Wipe down the inside of shutter system guides with a damp towel to remove any
dirt or debris.
• If you so choose, you can wash the security shutter curtain. Be sure to completely
close the shutter and wipe down curtain with towel and a mild cleanser. Be sure to
wipe off any cleanser with a clean towel.
Every six months
The above frequency of maintenance is for normal low cycle operation. Frequency
of operation or unusual operating conditions may require modification of the times
between maintenance.
• The guides should be lubricated with a paste wax or silicone spray.
• The bearing with a grease fitting, located on bracket attaching motor to shaft
should be lubricated.
BENEFITS OF PROFESSIONAL PREVENTATIVE
MAINTENANCE PROGRAM
There are many benefits to opting into a Professional Preventative Maintenance
Program, where the local dealer's technician services your shutter system on a
scheduled basis. Contact your local Wayne Dalton dealer for more details on their
program offering.
• Increase operational efficiency, safety and reliability
• Extend useful life of your equipment
• Reduce probability of equipment malfunctioning
• Decrease costly downtime
• Priority scheduling for service
• Establish relationship with experienced, service-oriented professionals
500367.0001 NEW 10/08/2020
MAINTENANCE INSTRUCTIONS
©Copyright 2020 Wayne Dalton, a division of Overhead Door Corporation
RECOMMENDED SCOPE OF WORK FOR PROFESSIONAL
SECURITY SHUTTER PREVENTIVE MAINTENANCE
PROGRAM
It is recommended that you arrange for a Wayne Dalton dealer's professional
installer/technician to perform the following as precautionary measures to keep
your shutter system running smoothly and to maximize the life of the product.
SECURITY SHUTTER:
WARNING
Never remove, adjust, or loosen the bolts, screws and/or lag screws
on the spring system of the door. These components are connected
to the spring(s) and are under extreme tension. To avoid possible
severe or fatal injury, have any such work performed by a trained
door systems technician using proper tools and instructions.
1) Inspect shutter alignment and level.
2) Inspect slats and endlocks for damage.
3) Inspect all guides, bottom bar and hood for damage.
4) Inspect all bottom astragal for wear or damage.
5) Inspect and lubricate bearings.
6) Inspect fasteners.
7) Inspect locks for proper operation.
8) Inspect safety labels, placement and condition.
MOTOR OPERATORS:
1) Inspect and adjust limit switches.
2) Inspect operator mounting.
3) Inspect and test disconnect for manual override.
20
Advertisement
Table of Contents
