Table of Contents
Advertisement
13
MAINTENANCE
■ Resetting
Occasionally, erroneous information will be displayed when,
for example, first applying power. This may be caused exter-
nally by static electricity or by other factors.
If this problem occurs, turn OFF power.
After waiting a few seconds, turn ON power again. If the prob-
lem is still there, perform a Partial reset or an All reset.
D Partial Reset
A Partial reset resets the operating settings to their default
values (VFO frequency, VFO settings, MENU contents) with-
out clearing the items below:
• Memory channel contents
• Call channel contents
Push [MENU
q
• Enters the MENU mode.
w Rotate [DIAL]S to select "PART" (
( MENU-EXMENU > EXMEN-OTHERS >
OTHER-RESET > RESET-PART)
ï]D.
Push [
e
• Displays "RESET?"
Rotate [DIAL]
S to select "YES."
r
ï]D.
Push [
t
• The transceiver displays "PART RESET," then the partial reset is
completed.
81
• Scan Edge contents
• DTMF memory contents
]C.
).
Partial reset
D All Reset
BE CAREFUL! An All reset clears all programming and
returns all settings to their factory defaults. See the Full
Manual for details.
Push [MENU
]C.
q
• Enters the MENU mode.
w Rotate [DIAL]S to select "ALL" (All
( MENU-EXMENU > EXMEN-OTHERS >
OTHER-RESET > RESET-ALL)
ï]D.
Push [
e
• Displays "RESET?"
Rotate [DIAL]
S to select "YES."
r
ï]D.
Push [
t
• The transceiver displays "ALL RESET," then the all reset is com-
pleted.
D isplay
S ide
C enter
S ide
).
reset
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
D: Display
Advertisement
Table of Contents
