Icom i2730A Instruction Manual page 44

5
SCAN OPERATION
Entering scan edges (Continued)
■
1. Entering a scan name
Push [MENU
q
• Enters the MENU mode.
w Rotate [DIAL]S to select "P-EDGE" (
(MENU-EXMENU > EXMEN-SCAN > SCAN-P-EDGE)
Push [ ï]D.
e
• Goes to the next tree level.
Rotate [DIAL] S to select a desired scan edge channel.
r
(Example: P03)
ï]D.
Push [
t
• Goes to the next tree level.
• Push [Ω]D to go back to the previous tree level.
Rotate [DIAL] S to select "NAME."
y
ï]D to display the Scan name entry screen.
Push [
u
Rotate [DIAL] to select a desired character or symbol.
i
S
(Example: SCAN03)
39
]C.
Program Scan Edge
Scan name entry
screen
• Selectable characters and symbols:
[A] [B] [C] [D]
[N] [O] [P] [Q]
).
[0] [1] [2] [3]
'
[$] [%] [&] [ ]
[ ] [<] [ = ] [>]
• Push [CLR]D to delete the selected character or symbol.
• When no character or symbol is selected, push [≈](D) to enter
a space.
Push [ Ω] to move the cursor backwards, or push [≈] to
o
move the cursor forwards.
!0 Repeat steps u and i to enter a name of up to 6 charac-
ters, including spaces.
!1 After entering, push [ï]D.
2. Entering a scan frequency
NOTE: You must enter different frequencies in "FREQ L" and
"FREQ H," to specify a scanning frequency range. If identical
frequencies are entered, the Program scan will not work.
!2 Rotate [DIAL]S to select "FREQ L."
!3 Push [ï]D to display the Lower edge frequency setting
screen.
[E] [F] [G] [H] [ I ] [J] [K] [L]
[R] [S] [T] [U] [V] [W] [X] [Y]
"
[4] [5] [6] [7] [8] [9] [!] [ ]
∗
/
[ ( ] [ ) ] [ ] [ + ] [ , ] [ - ] [ . ] [ ]
[?] [@] [ [ ] [ \ ] [ ] ] [ ^ ] [Space ]
[M]
[Z]
[#]
[ : ]