Selecting The Menu Item - Icom i2730A Instruction Manual

2
MENU MODE

■ Selecting the MENU item

In addition to this page, see pages 12 through 22 for details.
For your reference:
The MENU system is constructed in a tree structure. You
can go to the next tree level, or go back a level, depending
on the selected item.
Example: Set the tuning step
Push [MAIN BAND]
q
set.
• Selects the Main band.
Push [MENU
w
• Enters the MENU mode.
e Rotate [DIAL]S to select the "MENU-TS" (Tuning step)
item.
Push [ ï]D.
r
• Goes to the next tree level.
• Pushing [≈]D also goes to the next tree level.
11
S of the band that the tuning step is
]C.
Rotate [DIAL] S to select the desired value.
t
Selectable values:
5 kHz, 6.25 kHz, 8.33 kHz*, 10 kHz, 12.5 kHz, 15 kHz,
20 kHz, 25 kHz, 30 kHz, 50 kHz, or AUTO*.
*Appears only when the AIR band is selected.
Push [ ï]D.
y
• Sets the selected value, and goes back to the previous tree level.
• Pushing [Ω]D also goes back to the previous tree level.
Push [MAIN BAND]
u S.
• Exits the MENU mode.
• Pushing [V/MHz SCAN]S or [MR CALL]S also exits the MENU
mode.
To return to the default setting:
Hold down [MR CALL] after doing step r.
D isplay
S ide C enter S ide
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
D: Display