Scan Operation; About The Scan Function - Icom i2730A Instruction Manual

■ About the scan function

D VFO scan
(p. 41)
• ALL (Full scan)
Repeatedly scans the entire band.
118 MHz
Scan
P SKIP
Jump
• BAND (Selected band scan)
Scans all frequencies over the entire selected band.
Band edge
Scan
P SKIP
Jump
• PROG 0~24 (Program scan)
Scans the program scan edge range.
Band
Lower
Scan edges
edge freq.
Jump Scan
• P-LINK0~9 (Program link scan)
Sequentially scans the program scan edge ranges which
are set to link in the "P-LINK" (Program Link) item of the
EXMENU mode. (p. 14)
550 MHz
P SKIP
Band edge
P SKIP
Higher Band
freq. edge
Jump

SCAN OPERATION

For your reference: The frequencies that are set as
"PSKIP" are not scanned. (p. 13)
NOTE: At least one program scan edge range must be
programmed to start a program scan. (p. 38)
D Memory scan
(p. 43)
• ALL (Full memory scan)
Scans all Memory channels.
• BAND (Selected band memory scan)
Scans all Memory channels in the same frequency band as
the selected channel.
• MODE (Mode memory scan)
Scans Memory channels that are programmed with the
same receiving mode as the currently selected mode.
D Memory bank scan
• ALL (Full bank scan)
Scans all banks.
• B-LINK (Bank link scan)
Sequentially scans the banks that are set to link in the
"B-LINK" (Bank Link) item of the EXMENU mode.
• BANK-A~J (Bank scan)
Scans the Memory channels in the selected bank.
For your reference: The frequencies that are set as
"PSKIP" or "SKIP" are not scanned. (p. 44)
NOTE: Two or more memory channels must be pro-
grammed to start a Memory scan.
5
(p. 43)
5
36