Selecting A Memory Or Call Channel; Selecting A Memory Channel - Icom i2730A Instruction Manual

4
MEMORY OPERATION

■ Selecting a Memory or Call channel

D Selecting a Memory channel
You can select a Memory channels by rotating [DIAL]S in the
Memory mode.
• Independently selectable on both the left and right
bands.
Push [MR CALL]
q
S.
• Selects the Memory mode.
Rotate [DIAL] S to select a Memory channel.
w
• Blank channels are not selected.
Appears
For your reference: Using the HM-207 microphone (p. 6)
Push [VFO/MR
q
Enter the Memory channel number, and then push [ENT].
w
• When you enter a 3-digit channel number, pushing [ENT] is not
necessary
D isplay
S ide C enter
29
] to select the Memory mode.
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
S ide
D: Display
D Selecting a Call channel
You can select the Call channels (C0/C1) by rotating [DIAL]S
in the Call channel mode.
Factory default frequencies and operating modes are preset
into the Call channels.
Change these to suit your operating needs.
C0 is for VHF or AIR band, and C1 is for UHF band.
• Independently selectable on both the left and right
bands.
Hold down [MR CALL] S for 1 second.
q
• Selects the Call channel mode.
Rotate [DIAL] S to select a Call channel.
w
Displays the Call channel number
For your reference: Using the HM-207 microphone (p. 6)
Hold down [HOME CALL] for 1 second to select the Call
q
channel mode.
Push [ ∫] or [√] to select a Call channel.
w