Directly Entering Into A Memory Bank; Selecting The Memory Bank Mode - Icom i2730A Instruction Manual

4
MEMORY OPERATION
Setting a Memory bank (Continued)
■
D Directly entering into a Memory bank
You can also enter the memory content directly into a memo-
ry bank channel. This way is a short cut to creating a memory
channel, and then assigning it to a bank.
In that case, the transceiver automatically selects the lowest
blank memory channel, to enter content into.
Example: Writing 434.100 MHz into Bank group "A."
Push [V/MHz SCAN]
q
• Selects the VFO mode.
Set the operating frequency to 434.100 MHz.
w
Push [MW] C to display the Memory write screen.
e
Rotate [DIAL] to select "BANK."
r
S
Push [ ï]D.
t
Rotate [DIAL] to select a Bank group "A."
y
S
Push [ ï]D.
u
Rotate [DIAL] to select "WRITE."
i
S
Push [ ï]D.
o
• Displays "WRITE?."
!0 Rotate [DIAL] to select "YES."
S
!1 Push [ï]D.
• Sounds beeps, writes the memory content to the bank channel,
and returns to the VFO mode.
33
S.
Select
D Selecting the Memory bank mode
When you select the Memory bank mode, rotating [DIAL]
lects only the bank channels assigned to the selected bank.
Push [MR CALL]
q S.
• Selects the Memory mode.
Hold down [MAIN BAND] S for 1 second.
w
Rotate [DIAL] to select a desired Bank group.
e
S
• Displays the Bank name, if entered.
Push [MAIN BAND]
r S.
• Selects the Memory bank mode.
Rotate [DIAL] to select a desired Bank channel.
t
S
• Blank channels are not displayed.
• To return to the Memory channels display, select a Memory
channel in step e.
D isplay
S ide C enter S ide
se-
S
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
D: Display