Resetting; Dpartial Reset; Dall Reset - Icom IC-V3500 Advanced Manual

9. OTHER FUNCTIONS

Resetting

Occasionally, erroneous information will be displayed when, for example, first applying power� This may be caused
externally by static electricity or by other factors� If this problem occurs, turn OFF the transceiver� After waiting a
few seconds, turn ON the transceiver again� If the problem is still there, perform a Partial reset or an All reset�
BE CAREFUL! An All Reset clears all settings and returns all settings to the factory defaults�

DPartial Reset

1� Hold down [ ] for 1 second to turn OFF the
transceiver�
2� While holding down [V/MHz SCAN], hold down [ ]
for 1 second to turn ON the transceiver�
TIP: A Partial Reset resets the operating settings to
their default values (VFO frequency, VFO settings,
the Set mode, the Initial Set mode, and the Option
Set mode contents) without clearing the items below:
• Memory channel contents
• Scan Edge channel contents
• Call channel contents
• DTMF Memory contents

DAll Reset

1� Hold down [ ] for 1 second to turn OFF the
transceiver�
2� While holding down [SET LOCK] and
[S�MW MW], hold down [ ] for 1 second to turn
ON the transceiver�
• "CLEAR" is displayed�
[ ]
MUTE
NAR
MID
LOW
LOCK
S ET
[ ]
[SET LOCK]
[S�MW MW]
MUTE
NAR
MID
LOW
MUTE
NAR
MID
LOW
LOCK
S ET
9-5
[V/MHz SCAN]
DIGITAL PRIO AO BUSY
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/MHz
DIGITAL PRIO AO BUSY
DIGITAL PRIO AO BUSY
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/MHz