Table of Contents
Advertisement
5
Man-Machine Interface (MMI) – Display with User Guide
Getting started
Status information
User guide
Logo
Access protection
82
BinTec Access Networks GmbH
5.1
Overview
You can use the MMI to enter X4100/200/300's IP address and netmask without
first having to set up a serial connection to the equipment. This simplifies the
initial configuration, as you can first assign an IP address to
then set up the equipment and connect it in the planned location. The configu-
ration is then carried out from your PC via your network (e.g. using the Setup
Tool).
The display of status information in the MMI enables you to monitor
300
activities without having to log in. This provides an additional diagnostic
tool, which can display information such as the current version of system soft-
ware or the activities of the equipment interfaces.
Illuminated input keys and navigation bars simplify operation of the MMI and
guide you through the menu architecture so that you can make settings in each
menu without having to search for each menu individually. You can still open a
certain menu if you wish.
After switching on,
X4100/200/300
the equipment logo on the display (see
to use the MMI. If no more inputs are made for a long period of time, the MMI
returns to the logo. You can set this period of time in the "Display Idle Timer"
menu.
The equipment logo is normally shown on switching on
expiry of the display idle timer.
You can replace the equipment logo with any MMI menu by showing the
desired menu on the display and then pressing C and OK at the same time.
The corresponding menu then appears instead of the logo when the idle timer
expires. This enables you, for example, to display a certain interface of
200/300
for monitoring purposes.
The MMI is operated in Configuration Mode as the default mode and all MMI
functions can be used. In Monitoring Mode, each menu can be displayed, but
entries are only possible to a limited extent. For example, the IP address en-
tered can be displayed in Monitoring Mode, but not changed.
first performs a few selftests and then shows
figure 5-1, page
81). Press any input key
X4100/200/300
X4100/200/300
and
X4100/200/
or on
X4100/
Advertisement
Table of Contents
Troubleshooting
