Activating The Classification - BinTec X4100 User Manual

Quality of Service (QoS)
7.4.3

Activating the Classification

Define the interface on which the previously defined classification is to be per-
formed in the menu Q
O
X4x00 Setup Tool
[QoS][INTERFACES]: Enable IP QoS Classification and Policies
Interface First Rule
call-by-call no IP QoS classification
dialup1 no IP QoS classification
en1 no IP QoS classification
en1-snap no IP QoS classification
en4 no IP QoS classification
en4-snap no IP QoS classification
EXIT
Use <Space> to select
Only one rule chain per interface can be created at any one time. If several IP
filters are to be used on an interface, these must be interlinked via a rule chain.
You must be especially careful if overlapping occurs between several filters
(cut sets or subsets). Note that processing a rule chain for each IP packet
stops as soon as one of the filter conditions is fulfilled.
Select the desired interface, e.g.
The following menu opens for Ethernet interfaces:
X4x00 Setup Tool
[QoS][INTERFACES][EDIT]: Configure QoS Policies
Interface
IP QoS Classification via
Use <Space> to select
S I P
NTERFACES AND
First Filter Scheduler
en1 , and confirm with Return.
en1
RI 1 FI 1 (test1)
SAVE
X4100/200/300
.
OLICIES
BinTec Access Networks GmbH
MyRouter
TxRate Limit
BinTec Access Networks GmbH
MyRouter
CANCEL
User's Guide
7
255