Table of Contents
Advertisement
Procedure for Initial Configuration
Internet access with
X4100/200/300
Windows 2000
And finally,
4.5.3
Configuring a PC
You can set up WAN access over X4100/200/300, e.g. to the Internet, for all
PCs located in a network with X4100/200/300. In order to do this, you must en-
ter
X4100/200/300
as gateway and as DNS for all those PCs that were not con-
figured as DHCP clients. Proceed as follows:
In the start menu click Settings
Select TCP/IP in the network components list (for Windows NT it is in the
Protocol tab) and click Properties.
Enter the IP address of
Gateway. Click Add. (Windows NT: Click the IP Address tab and enter the
IP address of
X4100/200/300
Click the DNS Configuration tab and enter the IP address of
300
under DNS Server Search Order. Click Add and then OK. Follow the
instructions on the screen.
Click the Windows Start button and then Settings
Connections.
Double click LAN Connection.
Click the General tab and then Properties.
Select the Internet Protocol (TCP/IP) in the General tab. Click Proper-
ties.
Activate the Use next IP address option in the General tab. Determine the
IP address, netmask and standard gateway. Enter the IP address of
200/300
as default gateway.
If you do not have your own DNS, enter the IP address of
as DNS address. Activate the Use next DNS server addresses option.
Enter the IP address and click OK.
Close the open windows with OK and Close.
Confirm all entries and restart your PC.
Repeat the installation for all the PCs in your network.
Control Panel. Double click Network.
X4100/200/300
in the Gateway tab under New
under Standard Gateway).
X4100/200/300
User's Guide
4
X4100/200/
Network and DCN
X4100/
X4100/200/300
79
Advertisement
Table of Contents
Troubleshooting
