Procedure For Initial Configuration - BinTec X4100 User Manual

4
Configuration Requirements
76 BinTec Access Networks GmbH
4.5

Procedure for Initial Configuration

We recommend the following procedure for initial configuration of
300:
Prepare the configuration as described in
Install BRICKware
Configure your PC as described in
Carry out the first configuration steps using the MMI (see
page 81). X4100/200/300
work, only the power cord must be connected:
– set the desired display language
– enter the IP address and netmask
Connect X4100/200/300
Create a basic configuration with the Setup Tool (see
You can then carry out the following:
– Configure further functions with the Setup Tool (see
page 173.
– Configure your expansion card with the Setup Tool (see
page 271).
– Configure security functions with the Setup Tool (see
page 293).
chapter 4.5.1, page
as described in chapter 4.5.2, page
chapter 4.5.3, page
should not yet be connected to the LAN for this
as explained in chapter 3.4, page
X4100/200/
77.
78.
79.
chapter 5,
46.
chapter 6, page 99)
chapter 7,
chapter 8,
chapter 9,