Connecting Over A Lan - BinTec X4100 User Manual

Connection Methods
To do
Assigning IP
addresses
Running telnet
Windows
4.1.3

Connecting Over a LAN

You can reach X4100/200/300
net is normally available on every PC. To be able to reach your
over the LAN, the router must already have an
netmask. If this is not the case and
been configured, you have two options:
Enter the IP address and netmask via the input keys of the MMI (see
chapter 5, page 81).
If you are using Windows, you can assign
using the DIME Tools
Tools together with
chapter 4.5.2, page
Proceed as follows to access
Connect X4100/200/300
To assign your X4100/200/300
Tools program, proceed as follows:
Click the Windows Start button and then Programs
DIME Tools.
If the BootP
The BootP server window opens after a short time if
unconfigured.
Enter the name and IP address of your
Device Parameter.
Click OK.
Close DIME Tools.
Now establish a connection to
Click Run... in the Windows Start menu.
Type telnet <IP address of X4100/200/300>.
from the LAN over the
X4100/200/300
X4100/200/300
assistant. If you have not yet installed
BRICKware for Windows, proceed as explained in
78.
X4100/200/300 over the LAN:
to the LAN.
an IP address (if necessary) with the
server is not started automatically, start it manually.
X4100/200/300
X4100/200/300
X4100/200/300
telnet service. Tel-
X4100/200/300
IP address and
has therefore not yet
an IP address by
BRICKware
X4100/200/300
in the window under
with telnet:
User's Guide
4
DIME
DIME
is still
57