Always On/Dynamic Isdn (Ao/Di) - BinTec X4100 User Manual

7
Advanced Configuration of Basic Unit with the Setup Tool
To do
190 BinTec Access Networks GmbH
Proceed as follows:
Go to WAN P
ARTNER
I S
NTERFACE ETTINGS
Select the desired value for Mode and Line Utilization Weighting.
Enter the desired value for Line Utilization Sample (sec).
Press SAVE.
Confirm with OK.
Go to WAN P
ARTNER
Enter Number.
Select Direction.
Select Direction = outgoing if you have set Mode = Bandwidth On Demand
Active .
Select Direction = incoming (CLID), if you have set Mode = Bandwidth On
Demand Passive .
Press SAVE.
Go to WAN P
ARTNER
Select Authentication.
Enter Partner PPP ID, Local PPP ID and PPP Password, if applicable.
Confirm with OK.
Press SAVE.
The settings are configured.
7.2.4

Always On/Dynamic ISDN (AO/DI)

Always On/Dynamic ISDN (AO/DI) uses the existing ISDN infrastructure to con-
figure a new service for the user without hardware changes: AO/DI is a perma-
nently available (always on) but nevertheless low-cost connection from the end
customer to the service provider. Only Deutsche Telekom provided this feature
at the time this manual was printed.
E A
DIT DVANCED
( ) .
OPTIONAL
E WAN N
DIT UMBERS
E PPP .
DIT
S E
ETTINGS XTENDED
ADD.