Settings Specific To Wan Partners; Delay After Connection Failure - BinTec X4100 User Manual

Settings Specific to WAN Partners

7.2 Settings Specific to WAN Partners
Specific functions for
acteristics for connections to WAN partners individually. Carry out the configu-
ration steps described separately for each WAN partner.

Delay after Connection Failure

Channel Bundling (chapter 7.2.2, page
Bandwidth on Demand (BoD)
Always On/Dynamic ISDN (AO/DI)
Application-Controlled Bandwidth Management
Layer 1 Protocol (ISDN B-Channel)
IP Transit Network
Transfer of DNS and WINS Server IP Addresses to WAN Partners
(chapter 7.2.8, page
RIP (Routing Information Protocol)
Compression:
page 213)
Proxy ARP
page 215)
Keepalive Monitoring
The configuration steps necessary in each case are explained in detail below.
7.2.1 Delay after Connection Failure
This function enables you to set the period of time
an unsuccessful attempt to set up a call.
WAN partners make it possible to define the char-
(chapter 7.2.1, page
184)
(chapter 7.2.3, page
(chapter 7.2.4, page
(chapter 7.2.6, page
(chapter 7.2.7, page 205)
208)
(chapter 7.2.9, page
VJHC, STAC, MS-STAC
(Address Resolution
(chapter 7.2.12, page
X4100/200/300
183)
186)
190)
(chapter 7.2.5, page
203)
211)
(chapter 7.2.10,
Protocol) (chapter 7.2.11,
218)
X4100/200/300 is to wait after
User's Guide
7
198)
183