Isdn Connections - BinTec X4100 User Manual

11
Troubleshooting
368 BinTec Access Networks GmbH
If an IP address has been entered, try to set up a serial connection:
Connect your PC to
Log in as the user admin with the corresponding password.
Start the Setup Tool with setup.
Check if a configuration error is the cause: Have you entered a filter under
IP A L
CCESS ISTS
rections.
If a serial connection does not work either:
Check the settings of the terminal program (see
you have changed the default settings in BOOTmonitor, adjust your termi-
nal settings accordingly.
If this doesn't succeed, proceed as described under
password.", page 367.
11.2.2

ISDN Connections

Here you will find possible causes of errors in ISDN connections.
Your telephone bill is unusually high.
Use the Credits Based Accounting System (see
enables you to set a limit for connections to
essary charges accumulating as a result of mistakes made during configura-
tion.
X4100/200/300 possibly has ISDN connections that remain connected or un-
wanted ISDN connections are set up, which cause additional costs.
Use debug all or trace to check if a PC in the LAN is using a different
netmask from the one entered on X4100/200/300.
Use debug all or trace to check if a PC in the LAN is configured for Re-
mote CAPI with an incorrect IP address (destination port 2662).
X4100/200/300 over the serial interface.
that is locking you out? If so, make the required cor-
chapter 9.1.3, page
X4100/200/300
chapter 4.1.2, page 55). If
"I have forgotten my
303). This
to prevent unnec-