General Safety Precautions - BinTec X4100 User Manual

Transport and storage
Installation and
operation
2

General Safety Precautions

General Safety Precautions in English
The following sections contain safety precautions you are strongly advised to
heed when working with your equipment.
Only transport and store
other appropriate packaging to protect against knocking and shaking.
Read the information on the ambient conditions (see Technical Data) be-
fore installing and operating X4100/200/300. Place the equipment on a firm
flat base.
Electrostatic charges may cause damage to the equipment. You should
therefore wear a grounded wrist strap or touch a grounded surface before
you touch sockets or extension cards of X4100/200/300. Only grip exten-
sion cards at the edges and do not touch components or conductor tracks.
Keep the unused extension slot covered with the dummy cover to prevent
objects getting inside the equipment. Foreign bodies located in the equip-
ment during operation create a danger of electric shock and short-circuits.
Ensure that no sharp objects can damage the window of the display mod-
ule. Protect the display module against knocks and dropping and only con-
nect it to the RJ11 socket provided for this purpose on
prevent damage to
Make sure the cables do not cover the ventilation slots of the equipment or
interfere with ventilation. Obstructing the ventilation of
cause damage to the equipment. Damage caused by lack of ventilation in-
validates the guarantee.
Never open the basic unit or tamper with the mains unit in any way, as this
can create a lethal danger through electric shock. Don't remove any fixing
screws on the basic unit.
Condensation may occur externally or internally if the equipment is moved
from a colder room to a warmer room. When moving the equipment under
such conditions, allow ample time for the equipment to reach room temper-
X4100/200/300 in its original packaging or use
X4100/200/300 and the display module.
X4100/200/300
X4100/200/300
X4100/200/300
User's Guide
2
to
may
27