Wan Interface Card For Isdn Pri And/Or - BinTec X4100 User Manual

WAN Interface Card for ISDN PRI and/or G.703
PRI
G.703
8.2

WAN Interface Card for ISDN PRI and/or

G.703
The Primary Rate Interface or G.703 expansion card is equipped with two ports,
each with two sockets (IN and OUT). By installing the expansion card, you can
equip X4100/200/300 with the following optional interfaces:
one ISDN PRI and/or one G.703 interface or
two ISDN PRI interfaces or
two G.703 interfaces
The necessary licenses for activating the desired interfaces can be obtained
from your dealer.
You can connect X4100/200/300's ISDN PRI interface to a Primary Rate Inter-
face. This is done by connecting the Network Termination (NT) adapter of your
telephone provider to the IN socket of a port activated by license. In Germany,
this provides you with 30 B-channels and 1 D-channel, which you can use for
both dialup and leased lines over ISDN.
With an X4100/200/300
a connection partner. This is also done by connecting the NT (Network Termi-
nation) adapter of your telephone provider to the IN socket of a port activated
by license. A G.703 leased line is an unstructured high-speed line of up to 2
Mbps for the transmission of data with HDLC framing. The connection status is
not checked at layer 1; if necessary, this must be done by higher protocol layers
such as the PPP.
You can use a PRI interface as both a PRI and G.703 interface.
You can only use a G.703 interface as a G.703 interface.
The PRI or G.703 expansion card is equipped ex works with hardware support
for encryption and compression
equipped with up to two resource cards with digital modems
page 283).
G.703 interface, you can install a G.703 leased line to
(chapter 8.5, page
X4100/200/300
292) and can be optionally
(chapter 8.4,
User's Guide
8
275