Changing The Password - BinTec X4100 User Manual

Using the Setup Tool
Make sure the cursor is positioned in a list field.
The search cannot run if the cursor is located in a command field, e.g. ADD or
DELETE.
Example:
In the WAN P
ARTNER
search results:
Entry
p or P
pr, Pr, pR, PR
p a r t n e r 2
Table 4-4: Search results
4.4.4

Changing the Password

The procedure described below for changing the password applies to all
200/300 passwords: the access passwords for the user names admin, read
and write, the RADIUS password, the PPP password, the provider password
and the CAPI user passwords.
Any character may be used for entering a password. Passwords are only dis-
played as asterisks, even during password changes. The number of asterisks
is the same as the number of characters in the password.
To start the X4100/200/300
displayed in plain language and can be changed once by editing, you must
enter the command setup -p. This option only exists if you have logged in on
X4100/200/300 under the user name admin.
menu shown above, the entries provide the following
Cursor moves to entry
Partner1
PROVIDER
Partner1, on entering 2 to Partner2
Setup Tool in a mode in which the passwords are
X4100/200/300
X4100/
User's Guide
4
69