Preparing For The Remote Control - Christie LW502 Setup Manual

Preparing for the remote control

Insert the batteries into the remote control before using it. If the remote control
starts to malfunction, try to replace the batteries. If you do not plan to use the
remote control for long period, remove the batteries from the remote control and
store them in a safe place.
1.
Remove the battery cover.
2.
Align and insert the two AA batteries
according to their plus and minus
terminals as indicated in the remote
control. (Use the appropriate AA
carbon-zinc or alkaline batteries
(non-rechargeable) in accordance with
laws and regulations. Batteries are not
included.)
3.
Put the battery cover back to the former state.
WARNING ►Always handle the batteries with care and use them only as
directed. Improper use may result in battery explosion, cracking or leakage,
which could result in fire, injury and/or pollution of the surrounding environment.
• When replacing the batteries, replace both of the batteries with new batteries
of the same type. Do not use a new battery with a used battery.
• Use only the batteries specified. Do not use batteries of different types at the
same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not place a battery in fire or water. Keep batteries in a dark, cool and dry place.
• If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing the battery.
LW502/LWU502/LX602 Setup Guide
020-001101-03 Rev. 1 (02-2018)
5