Avaya IP Office Installation Manual page 42

Rack Mounting
With the exception of the Small Office Edition, all IP Office control units and external expansion modules can be rack
mounted into standard 19" rack systems. Each unit requires a 2U slot space within the rack. Rack mounting requires an
IP400 or IP500 rack mounting kit for each control unit and external expansion module.
Where IP Office systems are being rack mounted, the effect of conditions with the rack cabinet must be considered. For
example the rack temperature may be above the room temperature and airflow within the rack will be restricted. The
environmental requirements
• IP500 Rack Mounting Kit (SAP 700429202)
This kit contains all the components required for the rack mounting of a single IP500 control unit or IP500 external
expansion module. This includes screws for fixing of the brackets to the module, bolts for securing the module in the
rack and cable tidy brackets.
• IP400 Rack Mounting Kit (SAP 700210800)
This kit contains all the components required for the rack mounting of a single control unit or expansion module. This
includes screws for fixing of the brackets to the module and bolts for securing the module in the rack.
• Barrier Box Rack Mounting Kit (SAP 700293905)
Barrier boxes must be used for
boxes to be rack mounted and simplifies the number of connections to the protective ground point in the rack. This kit
must be used when more than 3 barrier boxes are in use and supports a maximum of 16 barrier boxes for a single
external expansion module.
IP Office Installation
IP Office
for the individual IP Office units are still applicable.
out-of-building analog phone
System Overview: Wall and Rack Mounting
extensions. This bracket allows up to 8 IP Office barrier
15-601042 Issue 20b (16 July 2009)
Page 41